...

Expert James Hardie Siding in Ballwin

Get A Free Quote

Get Started Today

Your Ballwin home deserves siding that outlives the next hailstorm and holds its color for a decade and a half. Call today and we will walk your elevations, show you real HardiePlank samples, and hand you a written quote inside the week.

Any questions?

James Hardie Siding Built for Ballwin Homes

Your 1970s ranch or split-level near Vlasis Park has probably worn its original hardboard or Masonite-style siding for four decades, and it shows — swollen edges, chalky paint, and soft spots where hail chewed through the face last spring. James Hardie siding in Ballwin fixes that cycle for good with a fiber cement plank engineered for humid Missouri summers, sub-zero January nights, and the hail that keeps rolling down the Manchester Road corridor. Top Quality Exteriors installs it as an official James Hardie Alliance Program Member.

Hardie boards resist rot, termites, and the 4.50-inch grapefruit hail that has hit near Ballwin in past storms, and they carry a 30-year non-prorated substrate warranty backed by a ColorPlus factory-baked finish. We wrap every job with rigid house wrap, corrosion-resistant nails, and a HardieTrim detail package that pulls the ranch profiles up to current curb standards. Homeowners upgrading from tired hardboard often bundle Hardie with siding installation in Ballwin on gable ends and dormers to keep the material lines clean.

Why Ballwin Chooses Hardie

  • Class 4 impact rating stands up to west-slope Ballwin hail
  • Non-combustible fiber cement rated for zero flame spread
  • ColorPlus finish carries a 15-year factory paint warranty

The Hardie Board Difference

HardiePlank lap siding is a Portland cement, sand, cellulose fiber, and water composite pressed under heat into 12-foot boards that weigh roughly 2.3 pounds per square foot — nine times heavier than vinyl and dimensionally stable across freeze-thaw swings that split hardboard every winter in Claymont and Seven Trails. We install the HZ5 formulation engineered for the wet, freeze-prone climate zone covering all of western St. Louis County, using blind-nailed 6d hot-dipped galvanized fasteners into studs 16 inches on center. Every course rests on a starter strip with a 1-1/4 inch overlap, kick-out flashing at every roof-to-wall termination, and caulked butt joints using paintable urethane. On tear-off jobs we replace sheathing where hardboard pulled water into the OSB, install a 60-minute drainable house wrap, then run HardieTrim 5/4 stock at corners, windows, and rakes. Pair that with fiber cement siding in Ballwin knowledge, and the elevation reads brand new.

Our 5-Step Hardie Process

We keep every Hardie install in Ballwin moving through the same five checkpoints so you know what happens next, when it happens, and who is standing on your driveway. Nothing slips between the first walk-through and the final magnet sweep.

Free Estimate

I meet you at the house and walk every elevation to log siding, damage, and trim. I photo swollen boards, soft spots, and flashing gaps. You get a written quote within a week.

Color Selection

We bring the full ColorPlus deck and Statement samples to your Ballwin home so paint chips read true in daylight. HOAs like Claymont need approval, and we file that on your behalf.

Permit and Prep

Ballwin routes exterior permits through St. Louis County, and we pull the paperwork so you never wait at a counter. Materials show up Monday, and ground protection goes down first.

Tear-Off Install

Old hardboard comes off in sections so sheathing never sits exposed. We swap any rotten OSB, wrap the walls, and blind-nail HardiePlank on 16-inch centers with hot-dipped nails.

Final Job Walk

We caulk each butt joint, touch up field cuts with ColorPlus paint, and pick up nails with a rolling magnet across the yard. You walk the whole house with me before we load out.

Alliance-Trained Ballwin Crews

Top Quality Exteriors is a James Hardie Alliance Program Member, and that badge means our lead installers train inside Hardie’s own program on the HZ5 climate spec, the fastener schedule, and the flashing details that make the 30-year non-prorated warranty stick. On every Ballwin re-side we run the same jobsite protocol — scaffold set, tarp perimeter, dust barriers on windows — so your driveway and lawn look the same Friday as they did Monday.

Owner Mario A. Granados runs every siding job through a mid-project quality check, and our 52-plus person team carries general liability and workers’ compensation insurance in both Missouri and Illinois. We are BBB Accredited with an A+ rating, and every install carries our firm 36-month workmanship warranty on top of Hardie coverage. Homeowners layering LP SmartSide siding in Ballwin onto outbuildings or detached garages get one contract and one schedule.

What Hardie Costs in Ballwin

A full HardiePlank re-side on a typical Ballwin ranch or split-level runs nine to thirteen dollars per installed square foot, which puts most 1,500 to 2,200 square-foot elevations in the twenty-two to thirty-eight thousand dollar range once trim, wrap, sheathing repairs, and disposal are included. That is a premium over vinyl, but it lands where the 1976-median housing stock recovers value at resale, and Hardie’s 30-year warranty carries with the deed.

Insurance often covers a big share when hail damage triggers the claim, and Ballwin’s April 1, 2024 storm alone hit roughly 1,527 properties, so many neighbors on your street are already inside the claim window. We accept Hearth and GreenSky financing with fixed monthly terms for qualified homeowners, and we itemize every line so nothing gets buried in a subtotal. Free written estimates, no charge for storm inspections, and no pressure to sign the day we visit.

Frequently Asked Questions

Most Ballwin re-sides land between twenty-two and thirty-eight thousand dollars for a full 1,500 to 2,200 square-foot home, or roughly nine to thirteen dollars per installed square foot. That number includes tear-off, HardieTrim, house wrap, any sheathing repairs, and disposal. We finance qualified homeowners through Hearth and GreenSky with fixed monthly terms.
For 1970s ranches and split-levels with tired hardboard, yes. Hardie survives hail that punctures vinyl, resists rot and termite damage, and holds the ColorPlus factory finish for a full fifteen years. Resale appraisers across western St. Louis County credit Hardie at a higher rate than mid-grade vinyl every single time we compare closing bids side by side.
HardiePlank carries a 30-year non-prorated substrate warranty, and the ColorPlus factory finish carries a separate 15-year paint warranty on top of that. Top Quality Exteriors layers our own firm 36-month workmanship warranty over both, and Hardie honors the substrate coverage anywhere in Ballwin the product is installed by an Alliance Program crew.
Yes. Claymont and other Ballwin subdivisions with active architectural review boards require color and material sign-off before any county permit is pulled. We prepare the color renderings, HardiePlank product cut sheets, and the trustee application form so the review board can comment, approve, and clear the color inside a single trustee meeting cycle.
A standard 1,800 square-foot ranch runs seven to ten working days from tear-off to final walk, weather permitting. Two-story split-levels near the Kehrs Mill corridor sometimes push out to two full weeks. We stage every material load to arrive the Monday of week one, so no HardiePlank ever sits exposed in your yard overnight or across a weekend of Missouri weather.
Yes. Ballwin routes building and exterior permits through St. Louis County rather than a city office, so we file the full application, pay the required county fee, and schedule any inspections on your behalf. You never take a day off work to sit inside a county waiting room just to get a siding permit approved, stamped, and returned to the project file.

Experience Shared by Our Customers

Every credential we carry is a commitment to quality, safety, and your peace of mind — on every project, in every state we serve.

Top Quality Exteriors LLC BBB Business Review
Seraphinite AcceleratorOptimized by Seraphinite Accelerator
Turns on site high speed to be attractive for people and search engines.